Lumal

Product:  Masonry cement MC 5 LUMAL  

Class of strength: 5 – according norm BAS EN 413-1:2005

Lumal is masonry cement mark MC 5. Intended for preparation of mortar for masonry, cement spray, as well as rough and fine plaster (for manual outside and inside plastering). Content minimally 25% of portland cement clinker and up to 75% addition of limestone mark L, up to 1% chemical additives and regulators for bonding (natural gypsum).

NOT TO BE USED FOR PREPARATION OF CONCRETE!

Manual for use:

Mortar for masonry:

Lumal: sand

Granulation of sand

Lumala quantities for 1m3 mort

1 : 3

0 – 4 mm

300-340 kg

1 : 4

0 – 4 mm

240-280 kg

Mortar for plastering:

Lumal: sand

Granulation of sand 

Lumala quantities for 1m3 mort 

1 : 2

0 – 4 mm

380 : 420  kg 

Required quantity of water is 200 – 250 l/m3 of mortar (depending on humidity and type of sand and required consistency of mortar) .

Remark: Ratios given in table are for informational purposes only. When preparing the mortar please follow the specific instructions. 

Physical and mechanical properties

Average values

Normative requirements

BAS EN  413-1:2005

Setting time (min)

100

≥ 60

Air content (%)

9-11

≥8 ≤ 22

Compressive strength on 28 days (MPa)

10

≥ 5 ≤ 15

Sulphate content (SO3%)

1,8

≤ 2 

Transportation and storage: 

  • to be transported in resources that protect cement from humidity influence ,
  • to be storage in dry place protected from atmospheric influence, above ground on pallets or other dry base ,
  • it is not recommended to pile more than 10 bags,
  • With adequate transportation and storage, cement is to be used within 6 months from packing date, marked on the bag.

Certificate of conformity 09/11 from 21.01.2011

Declaration on conformity for MC 5 LUMAL according to BAS EN 197-1:2002 and Regulation about technical properties for cement issued by “Fabrika cementa Lukavac d.d” (class number of statement  077/11 from21.01.2011)